Table of Contents
Advertisement
3. Insert a Phillips screw through each hole on the mounting bracket and chassis.
4. Use a Phillips screwdriver to tighten the screws.
5. Hold the chassis in position and align the flanged end of the mounting bracket with the holes
on either side of the rack support.
6. Ensure that the holes on either side of the rack supports match horizontally.
7. Insert a Phillips screw through each hole on the mounting bracket in the screw positions in
the flange and rack.
8. Use a Phillips screwdriver to tighten the screws.
Attaching the cable management
Use this procedure to attach the cable management brackets and cable management cover to the
top of the Virtual Services Platform 9010 chassis.
The cable management includes wire bales that swing out for dressing cables. The wire bales swing
back in place to latch and retain the cables. The top cover is placed over the cable management.
Before you begin
• Secure the chassis in the rack. Do not attach the cable management cover before you mount
the chassis in a rack.
October 2015
Virtual Services Platform 9010 chassis installation
Installing the Avaya VSP 9000
Comments on this document? infodev@avaya.com
37
Advertisement
Table of Contents
