Avaya Virtual Services Platform 9000 Installation Manual page 21

Value
This information applies only to second generation modules.
FPGA
FA
Slice-1 through Slice–3
Highest Temp
Lowest Temp
Alarm Threshold
Shutdown Threshold
Virtual Services Platform 9010 show sys-info output
On the Virtual Services Platform 9010, you can see the zone alarm information under the Fan Trays
Info section of the command output for the show sys-info command. The following output
displays on a Virtual Services Platform 9010 without a second generation module:
Fan Trays Info :
Zone Info :
FRONT zone :
Mode : NORMAL
Mode Status : Normal
Highest Temperature : 37 C
Extended Zone :
FPGA Highest Temperature : --
FA Highest Temperature : --
REAR zone :
Mode : NORMAL
Mode Status : Normal
Highest Temperature : 0 C
Fan Info :
Tray CardType
FAN 1
FAN 2
Zone
FRONT
FRONT
FRONT
FRONT
FRONT
October 2015
Serial#
9010CM
9010CM
Tray Unit
FAN 1 1
FAN 1 2
FAN 1 3
FAN 1 4
FAN 2 1
Installing the Avaya VSP 9000
Comments on this document? infodev@avaya.com
Virtual Services Platform 9010 chassis fundamentals
Description
Specifies the temperature of the FPGA sensors. A
value of -- indicates that this sensor is not available
on this slot.
Specifies the temperature of the FA sensor, located
on the slice. A value of -- indicates that this sensor is
not available on this slot.
Specifies temperature information for sensors on
each slice. Sensors provide temperature information
for various datapath components.
Specifies the highest temperature of all the FPGA or
FA sensors located on this I/O module.
Specifies the lowest temperature of all the FPGA or
FA sensors located on this I/O module.
Specifies the FPGA or FA temperature, when
exceeded by one degree, that causes an alarm.
Specifies the FPGA or FA temperature, when
exceeded by one degree, that causes the system to
shutdown the module by removing power from the
slot.
Part#
EC1411012-E6
EC1411012-E6
Status
OK
OK
OK
OK
OK
21