Table of Contents
Advertisement
• Ensure you have a 6-AWG green and yellow ground wire long enough to connect to the ground
point.
• Ensure you have a 1/4 inch (6 mm) socket or nut driver.
Procedure
1. Crimp the two hole lug onto the ground wire.
2. Attach the chassis ground cable to the grounding studs on the chassis. As shown in the
following figure, the grounding studs are located on the bottom right of the chassis rear.
3. Bond the chassis ground cable to the single point ground window.
Job aid
The following figure shows an example of how to attach the chassis ground cable to the rack
grounding strip.
Figure 6: Rack grounding strip example
October 2015
Virtual Services Platform 9010 chassis installation
Installing the Avaya VSP 9000
Comments on this document? infodev@avaya.com
43
Advertisement
Table of Contents
