Table of Contents
Advertisement
1-6-8. Cutter Unit
1. Remove the cabinet. (Refer to Section 1-4.)
2. Disconnect the harness and fl exible fl at cable from the
connectors (CN1 and CN3) on the KY-617 board.
3. Remove the harness from the four clampers of the
front stay (U1).
4. Disconnect the two harnesses from the connectors
(CN203 and CN402) on the MEC-33 board.
5. Cut the binding band.
6. Slide the carriage portion of the cutter unit to the
center.
7. Remove the three screws, then remove the cutter unit
in the direction of the arrow.
8. To install, reverse the removal procedure.
UP-CX2
Flexible flat cable
Harnesses
KY-617
board
CN1
CN3
Clampers
Binding band
Cutter unit
Carriage
BVTT
portion
3 x 6
Front stay (U1)
MEC-33
Harnesses
board
CN203
CN402
1-17 (E)
Advertisement
Table of Contents
