Table of Contents
Advertisement
5. Remove the ribbon drive assembly. (Refer to Section 1-6-2.)
6. Disconnect the harness from the connector on the SE-1056 board.
7. Remove the screw, then remove the FG bracket in the direction of the arrow C.
8. Remove the snap ring (E3.0), then remove the paper drive FG and parallel pin.
9. Remove the two snap rings (E4.0) and two bearings, then remove the paper drive roller in the direc-
tion of the arrow D.
10. Remove the paper drive gear (P) and parallel pin from the paper drive roller.
Bearing
E4.0
11. To install, reverse the removal procedure.
n
When attaching the inner cover (U), be sure to securely
attach the two portions B of the inner cover (U) to the
portions A of the return guide shaft.
1-20 (E)
Paper drive roller
Parallel pin
Paper drive gear (P)
D
C
SE-1056 board
BVTT
3 x 6
FG bracket
Bearing
Parallel pin
Harness
E4.0
Paper drive FG
Portions B
Inner cover (U)
E3.0
Return guide shaft
Portions A
UP-CX2
Advertisement
Table of Contents
