1-5. Replacing the Board
n
Tighten the each screw with the torque below.
Tighten torque:
. BVTT3 x 6
0.80 ?0.05 N.m
. PS3 x 4
0.80 ?0.05 N.m (For USB connector, 0.60 ?0.05 N.m)
1-5-1. MEC-33 Board
1. Remove the top panel (C2) assembly. (Refer to Section 1-4-1.)
2. Disconnect all harnesses and fl exible fl at cables from
the connectors on the MEC-33 board.
3. Remove the four screws, then remove the MEC-33
board in the direction of the arrow.
4. To install, reverse the removal procedure.
UP-CX2
MEC-33 board (Side A)
CN100
CN103
CN102
CN200
CN202
CN203
CN302
CN403
CN404
Harnesses
BVTT3 x 6
MEC-33 board
CN101
CN301
CN300
CN401
CN400
CN411
CN406
CN405
CN402
Flexible flat
cable
1-7 (E)