Table of Contents
Advertisement
. [Ribbon|sense]: Checks the ribbon detection and ribbon sensing.
Confi rmation object: 1-wire interface (CT-266/267/268 board), ribbon (Y) start
Confi rmation method: 1. When installing/removing the ribbon cassette, the unit
. [Head]:
Checks the shifting the position of thermal head.
Confi rmation object: Head position motor, SU-114 board, and position sensor/
Confi rmation method: When clicking the [Head] button, head position is intermit-
. [Cutter]:
Check the cutter movement.
Confi rmation object: Cutter unit
Confi rmation method: When clicking the [Cutter] button, shifts the cutter from
. [Print|step]:
Prints the test pattern (16STEP) required for density adjustment.
16STEP
UP-CX2
mark sensor/RM-204 and RM-208 boards, and ribbon
(MCL) start mark sensor/RM-209 and RM-210 board
sounds bleep.
2. When clicking the [Ribbon|sense] button with the
ribbon cassette installed, shifts the thermal head to down-
ward, winds the ribbon for about 15 seconds, then shifts
the thermal head to upward. When Y start mark is passed
through, pin 1 of CN405 on the MEC-33 board changes
to high from low. When M/C/L start mark is passed
through, pin 4 of CN405 on the MEC-33 board changes
to high from low.
HP-131 board
tently shifted in the order of home, tray, media transport,
print, and home. Pins 7 and 8 of CN403 on the MEC-33
board change as following at each position.
. Pin 7: Changes to high from low seven times.
. Pin 8: Changes to high from low once.
side to side. When shifting the cutter, pins 1 and 3 of CN402
on the MEC-33 board change.
5-5 (E)
Advertisement
Table of Contents
