Table of Contents
Advertisement
1-6-6. DC Fan (for Inside)
n
When the DC fan (for inside) is replaced, it is required to initialize the cumulated rotation time history of
the fan.
For details, refer to "Operation during Replacement of Parts" in Section 2-1, and Section 2-4.
1. Remove the top panel (C2) assembly. (Refer to Section 1-4-1.)
2. Remove the side panel (R) assembly and side panel (L). (Refer to Section 1-4-2.)
3. Remove the rear panel (C1) assembly. (Refer to Section 1-4-3.)
4. Remove the screw (BVTT3 x 6), then remove the
PSW cover.
5. Remove the four screws (BVTT3 x 6), then remove
the power supply mounting bracket.
6. Disconnect the harness from the connector (CN300) on
the MEC-33 board.
7. Remove the two screws (BVTT3 x 10), then remove
the DC fan.
8. To install, reverse the removal procedure.
UP-CX2
BVTT
PSW cover
3 x 6
Harness
CN300
MEC-33
board
BVTT3 x 10
DC fan
BVTT
3 x 6
Power supply
mounting bracket
1-15 (E)
Advertisement
Table of Contents
