Table of Contents
Advertisement
2-5-4. Processing Required When Information Items Cannot Be Backed Up
The operation below is required when the information items stored on the MA-140 board cannot be read
during replacement of an MA-140 board.
When a value is written down in step 4 of "Backup of various information items"
(Section 2-5-1);
1. Start the service mode. (Refer to Section 5-2.)
2. Click the [Setting] button.
A Setting screen then appears.
3. Click the [Open] button of the Setting.
A Setting screen then appears.
4. Set the item values below to the values written down in step 4 of "Backup of various information
items".
. USB serial number (USB Serial)
. Thermal head resistance value (Head Resistance)
. Thermal head voltage value (Head Voltage)
. Takeup tension ratio of ribbon drive assembly (Takeup Ratio)
5. Click the [Apply] button.
When there is no backup;
1. Set the thermal head resistance value. (Refer to Section 2-2-3.)
2. Adjust the density. (Refer to Section 2-2-5.)
n
Compare a print with the print at that time when a test pattern (16STEP) before replacement exists.
When no print can be performed before replacement, compare a test pattern with the test pattern
(16STEP) printed using a normal unit for adjustment.
3. Set the takeup tension ratio. (Refer to Section 2-3-1.)
4. Set the USB serial number. (Refer to Section 2-5-5.)
2-5-5. Setting of USB Serial Number
1. Start the service mode. (Refer to Section 5-2.)
2-16 (E)
UP-CX2
Advertisement
Table of Contents
