Board; Se-1056 Board - Sony UP-CX2 Service Manual

1-5-3. KY-617 Board
1. Remove the top panel (C2) assembly. (Refer to Section 1-4-1.)
2. Disconnect the harness and fl exible fl at cable from the
connectors (CN1 and CN3) on the KY-617 board.
3. Remove the three screws, then remove the KY-617

board.

4. To install, reverse the removal procedure.

1-5-4. SE-1056 Board

1. Remove the top panel (C2) assembly. (Refer to Section 1-4-1.)
2. Remove the side panel (R) assembly. (Refer to steps 1 to 3 in Section 1-4-2.)
3. Disconnect the harness from the connector on the
SE-1056 board.
4. Remove the screw, then remove the FG bracket in the
direction of the arrow.
n
When removing the FG bracket, be careful not to
damage the paper drive FG.
5. Remove the screw, then remove the SE-1056 board.
6. To install, reverse the removal procedure.
UP-CX2
Harness
Flexible flat cable
CN1
CN3
KY-617 board
BVTT
3 x 6
Paper drive FG
BVTT
3 x 6
SE-1056 board
FG bracket
BVTT
3 x 6
Harness
1-9 (E)