Table of Contents
Advertisement
1-6-7. DC Fan (for Thermal Head)
1. Remove the top panel (C2) assembly. (Refer to Section 1-4-1.)
2. Remove the side panel (R) assembly and side panel (L). (Refer to Section 1-4-2.)
3. Remove the rear panel (C1) assembly. (Refer to Section 1-4-3.)
4. Remove the PSW cover and power supply mounting bracket.
(Refer to steps 4 and 7 in Section 1-6-1.)
5. Disconnect the harness from the connector (CN301) on
the MEC-33 board.
6. Cut the two binding bands.
7. Remove the two screws, then remove the DC fan.
8. To install, reverse the removal procedure.
1-16 (E)
DC fan
MEC-33
board
CN301
Binding bands
BVTT
3 x 10
Harness
UP-CX2
Advertisement
Table of Contents
