Rear Panel Assembly; Replacing The Board; Board - Sony UP-DR200 Service Manual

4. Remove the stepped screw, then remove the side panel
(L) assembly in the direction of the arrow.
Stepped screw
Side panel (L) assembly
5. Attach the side panel (R) assembly and side panel (L)
assembly in the reverse order of steps 1 to 4.

1-4-3. Rear Panel Assembly

1. Remove the four stepped screws, then remove the rear
panel assembly.
Rear panel assembly
2. Attach the rear panel assembly in the reverse order.
1-4

1-5. Replacing the Board

1-5-1. MEC-36 Board
1. Remove the top panel assembly.
(Refer to Section 1-4-1.)
2. Remove the side panel (R) assembly.
(Refer to Section 1-4-2.)
3. Disconnect the flexible flat cables and harnesses from
all connectors on the MEC-36 board.
4. Remove the four screws, then remove the MEC-36

board.

MEC-36 board Side A
Stepped
screws
5. Install the MEC-36 board in the reverse order of steps
1 to 4.
Stepped
screws
CN10
CN7
CN9
CN16
CN15
CN12
CN1
CN13
MEC-36 board
Harnesses
CN3
CN2
CN17
CN18
CN14
CN5
CN8
CN4
Flexible flat cables
BVTT3 x 6
Harnesses
Harnesses
UP-DR200