SaMASZ TANGO 730 Operator's Manual page 23

OPERATOR'S MANUAL
Fig. 15. Temporary mounting of arms
hammer expansion pins into holes where bolts were previously placed. put pin Ø10 and Ø6 into
❑
each one hole (Fig. 16).
Fig. 17. Hammering dowel pins
Before commissioning of the rake, in driving wheels (Fig. 19), replace provisional bolts (S
joints of steering heads with rear wheel axis for expansion pins Ø16 and Ø10 (K) delivered with the
machine. Install the pins as shown in Fig. 18.
TWO-ROTOR ROTARY RAKE
S
1
Fig. 19. Preparing drive system of the rake
TANGO 730
Fig. 16. Supporting rake arm
Fig. 18. Properly hammered pins
) on
1
K
23