Preparing Rake For Transport - SaMASZ TANGO 730 Operator's Manual

OPERATOR'S MANUAL
CAUTION! once diode (2) lights up the function remains active for 60 seconds. This time is sufficient
to fold the machine to transport position or unfold it to working position. As the 60 s time elapses the
panel will go to sequential operation mode.

5.2. Preparing rake for transport

CAUTION!
Switching the machine from working to transport position, and the other way
round can only be done on an even and stable ground. Prior to starting any works
make sure that nearby the machine there are no unauthorized persons exposed
to being crushed.
In order to prepare the rake for transport (drive on a road):
due to safety reasons, before setting the rake to transport position turn off the PTO shaft; raking
❑
arms cannot be in motion,
lift safety guards to transport position,
❑
take out the extreme most raking arms from a rotor, place them in transport holes (depending on
❑
max. height of obstacles under way) (Fig. 9),
put the tine protections,
❑
lift working assemblies and secure them with a pawl (P) (See point 5.9. Lifting rake on headlands
❑
and transport position),
lower and secure a support leg,
❑
490 mm / 1' 7''
TWO-ROTOR ROTARY RAKE
1
Fig. 8. Control panel
7400 mm / 24' 3''
7750 mm / 25' 5''
Fig. 9. Transport dimensions
TANGO 730
2
19