Table of Contents
Advertisement
CDM-A100 Series
4.
QuickStart
2
measurement device. Check that expected cable lengths were received.
Contact Campbell Scientific immediately if you find any discrepancies.
•
Check the
operating system
datalogger, and the
SC-CPI
Section 7.2, Operating Systems
Short Cut is an easy way to program your datalogger to measure sensors
through a CDM-A108 or CDM-A116 and assign wiring terminals. Short Cut is
available as a download on
www.campbellsci.com
included in installations of LoggerNet, PC200W, PC400, or RTDAQ.
This section will guide you through programming a CR6 datalogger to read a
single-ended voltage measured by a CDM-A108. With minor changes, these
steps can apply to other compatible dataloggers and measurements.
1.
Open Short Cut. Click New Program.
version in the CDM-A100, the
(p. 32)
(if used), and update as needed. See
(p. 33)
.
(p. 18)
and the ResourceDVD. It is
Advertisement
Table of Contents
