Initial Inspection; Quickstart - Campbell CS240 Product Manual

Pt-1000 class a, back-of-module temperature sensors

Hide thumbs Also See for CS240:

Table of Contents

3. Initial inspection

Upon receipt of the sensor, inspect the packaging and contents for damage. File damage

claims with the shipping company.

The model number, cable length, and cable resistance (CS240 only) are printed on a label

at the connection end of the cable. Check this information against the shipping documents

to ensure the expected product and cable length were received.

The information provided in this section is for the CS240.

A video that describes data logger programming using Short Cut is available at:

www.campbellsci.eu/videos/cr1000x-data logger-getting-started-program-part-3

is an easy way to program your data logger to measure the sensor and assign data logger

wiring terminals. Short Cut is available as a download on www.campbellsci.eu.

in installations of LoggerNet, RTDAQ, or PC400.

The following procedure also shows using Short Cut to program the CS240 and CS240DM.

1. Open Short Cut and click Create New Program.

2. Double-click the data logger model.

3. In the Available Sensors and Devices box, type CS240. You can also locate the sensor in the

Sensors > Temperature folder. Double click the sensor model. The surface temperature

defaults to degree C. This can be changed by clicking the Temperature box and selecting

one of the other options. If using the 2-wire configuration, type the Cable Resistance. This

value is unique for each sensor, and is printed on the heat shrink label attached to the

sensor cable.

CS240 and CS240DM PT-1000 Class A, Back-of-Module Temperature

. Short Cut

It is included

Sensors 2

Table of Contents

Cs240dm