Comm Status Led; Cpi Port Leds; Replacing A Cdm-A108 Or Cdm-A116; Cpi Port Led Activity - Campbell CDM-A100 Series Instruction Manual

Wait Config
Config Fail

10.3 COMM status LED

The COMM status
A100, as shown in TABLE
Orange

10.4 CPI Port LEDs

Green and Orange LEDs on the
the CPI bus as shown in TABLE
TABLE 10-3. CPI Port LED Activity
Orange

10.5 Replacing a CDM-A108 or CDM-A116

An existing CDM-A100 can be replaced with a new module using the same
CPI address without requiring a change to the program.
TABLE 10-1. CPIStatus Activity
Response
The module is connected to the
Active
measurements according to the datalogger program.
The module was present after startup but is no longer
Offline
responding.
The module is or was connected and powered but is not
Unused
included in the datalogger program.
The module has not yet responded to a datalogger's attempts
to configure it.
The module could not be configured. A configuration error
message is appended to this response.
LED indicates the current operation of the CDM-
(p. 32)
10-2
TABLE 10-2. COMM Status LED Activity
Green Flashing
Flashing
Single-Flash
Red
Double-Flash
Solid
Green Flashing Frame Sync
Flashing CPI activity
Solid CPI bus fault
CDM-A100 Series
Meaning
CPI bus and is making
(p. 32)
below.
Module has been configured by datalogger
and is receiving sync signals
Device has not been configured by
datalogger
Device has been configured but is not
receiving sync signals
Device has encountered a scan timeout
Error
CPI bus indicate the current operation of
(p. 32)
10-3 below.
31