Measurement Quickstart Using Surveyor; Example - Campbell GRANITE VOLT Series Product Manual

Inspect the packaging and contents for damage immediately. File damage claims with the
l
shipping company.
Check packaging materials for all products. Check model numbers, part numbers, product
l
descriptions, and cable lengths against shipping documents. Model or part numbers are
found on each product. Cable numbers are normally found at the end of the cable that
connects to the measurement device. Check that expected cable lengths were received.
Contact Campbell Scientific immediately if you find any discrepancies.
Check the operating system version in the VOLT 100 series, and the data logger. Update as
l
needed. See Operating systems
4. Measurement quickstart
using SURVEYOR
Campbell Scientific SURVEYOR software is an easy way to quickly see measurement results and
store data from the VOLT 100 series. The module configuration can be saved on the computer or
exported as a CRBasic data logger program. SURVEYOR is available as a download from
www.campbellsci.com/cs-surveyor.
This section will guide you through reading a differential Type-T thermocouple on a VOLT 100
series. With minor changes, these steps can apply to other compatible measurements.
1. Open SURVEYOR
2. Connect a USB cable between your computer and the VOLT 100 series USB port.
3. Apply 9.6 to 32 VDC external power using the green Power connector on the side of the
VOLT 100 series.
4. Select Connect Now
5. Select the communications port, it will be labeled similar to VOLT 100 series (COM3).
6. Make selections for Speed or Noise Rejection and CAN enabled. See the SURVEYOR help
for more information on all settings.
7. Click Apply.
8. Select a Sample Rate. For this exercise, select 10 Hz. (1/2 Hz is typical for thermocouple
measurements.)
(p. 22).
.
.
VOLT 100 series 2