Table of Contents
Advertisement
(a)
FIGURE 7-4. CDM DIN-Rail Mounting Kit
Follow the steps below to mount the CDM-A100 to a DIN rail.
1.
Using a Phillips screwdriver, unfasten both screws on the baseplate of the
CDM-A100 and remove the baseplate.
2.
Screw the rubber bumper into the bottom outer hole.
3.
Use the screw from the kit to attach the metal clip to the middle hole, with
the comb pointing up as shown in FIGURE
4.
Clip the CDM-A100 to a DIN rail. See FIGURE
(b)
FIGURE 7-5. Mounting the CDM-A108 to a DIN rail
CDM-A100 Series
7-5
(a).
7-5
(b) and (c).
(c)
23
Advertisement
Table of Contents
