Campbell CDM-A100 Series Instruction Manual page 17

Table of Contents

CDM-A100 Series

After selecting the measurement, click Wiring Diagram to see how the

sensor is to be wired to the datalogger. The wiring diagram can be printed

now or after more sensors are added. The CR6 Series tab shows the

connection between the CDM-A108 and the datalogger, and the CDM-

A108 tab shows the sensor connection to the CDM-A108.

Select any other sensors you have in the Sensors section, and then finish

the remaining Short Cut steps to complete the program. The remaining

steps are outlined in Short Cut Help, which is accessed by clicking on

Help | Contents | Programming Steps.

If LoggerNet, PC400, RTDAQ, or PC200W is running on your PC, and the

PC to datalogger connection is active, you can click Finish in Short Cut,

and you will be prompted to send the program just created to the

datalogger.

Table of Contents

Cdm-a108 Cdm-a116