Initial Inspection; Quickstart; Physical Setup; Nl116 Attached To A Cr1000 - Campbell NL116 Instruction Manual

NL116 Ethernet and CompactFlash
3.

Initial Inspection

4.

Quickstart

4.1

Physical Setup

CAUTION
CAUTION
NOTE
2
® Module
Shielded Ethernet cable should be used for cable lengths longer than 9 ft.
•
Always power down the datalogger before installing to or removing the
•
NL116 from the datalogger.
Upon receipt of the NL116, inspect the packaging and contents for damage.
File damage claims with the shipping company.
This section describes the basics of communicating via Ethernet and storing
and retrieving datalogger data. These operations are discussed in detail in
Section 7, Operation .
(p. 12)
Always collect your data before attaching the NL116.
Always power down the datalogger before installing to or
removing the NL116 from the datalogger.
After powering down the datalogger, plug the NL116 into the datalogger
peripheral port (see FIGURE 4-1). Attach Ethernet cable to the Ethernet port.
Restore power to the datalogger. Insert formatted CF card. (For instructions
on formatting a CF card, see Appendix A, CF Card Maintenance
A CF card does not need to be present in order to use the NL116's
IP functionality.
FIGURE 4-1. NL116 attached to a CR1000
.)
(p. A-1)