Table of Contents
Advertisement
5.
Overview
5.1
Wiring Panel – Overview
CAUTION
10. Wire the sensors and devices as shown in the wiring diagrams in step 7.
Check the output of the sensor in the
data display to make sure it is making reasonable measurements.
The CDM-A100 expands the number of analog measurement channels and
increases the measurement-speed potential in a datalogger system. CDMs
operate through a datalogger program and communicate using the CAN
peripheral interface
(CPI
(p. 32)
CDMs.
To avoid damage to sensors and devices, ensure that each
removable wiring-terminal strip is connected to the CDM-
A108 and CDM-A116 in the proper location before applying
power. Each strip is keyed identically.
datalogger support software
). A single datalogger can operate up to 50
CDM-A100 Series
(p. 32)
7
Advertisement
Table of Contents
