Module - Specifications; Communications; System; Power Requirements - Campbell CDM-A100 Series Instruction Manual

6.6 Module – Specifications

6.6.1 Communications

6.6.2 System

6.6.3 Power Requirements

6.6.4 Compliance

6.6.5 Physical Attributes

7.

Installation

7.1

Install Driver for PC Connection

CPI:
USB:
Processor:
Memory:
Voltage:
Typical Current Drain
Sleep:
1
Active 1 Hz Scan :
1
Active 20 Hz Scan :
1
Assumes one single-ended measurement with the first notch frequency (f
View EU Declarations of Conformity at
www.campbellsci.com/cdm-a116.
Dimensions:
Weight
CDM-A108:
CDM-A116:
Installing the CDM-A100 may require a connection to a PC. Install the device
driver before plugging the CDM-A100 into your PC for the first time. You will
need the device driver properly installed before you can connect to the CDM-
A100 via USB. To install the device driver using the
Utility , select Peripheral | CDM-A100 Series under Device Type. Click
(p. 32)
the Install the USB driver link and follow the prompts.
CDM-A100 Series
RJ45 interface to Campbell Scientific
dataloggers and CDM measurement
peripherals and sensors
USB micro-B device only, 2.0 full-speed
12 Mbps, for computer connection.
Renesas RX63N (32-bit with hardware FPU,
running at 96 MHz)
2 MB SRAM
9.6 to 32 Vdc
<1 mA
2 mA, estimated
20 mA
www.campbellsci.com/cdm-a108
20.3 x 12.7 x 5.1 cm (8 x 5 x 2 in);
additional clearance required for cables and
leads
0.8 kg (1.75 lb)
0.9 kg (1.95 lb)
Device Configuration
) at 30 kHz
N1
and
17