Measurement Quickstart Using Surveyor - Campbell TEMP 120 Product Manual

For more information on accessing the calibration certificate watch a video at
l
www.campbellsci.eu/videos/calibration-certs.
4. Measurement quickstart
using SURVEYOR
Campbell Scientific SURVEYOR software is an easy way to quickly see measurement results and
store data from the TEMP 120. The module configuration can be saved on the computer or
exported as a CRBasic data logger program. SURVEYOR is available as a download from
www.campbellsci.com/cs-surveyor
www.campbellsci.com/videos/surveyor
This section will guide you through reading a differential Type-T thermocouple on a TEMP 120.
With minor changes, these steps can apply to other compatible measurements.
1. Open SURVEYOR
2. Connect a USB cable between your computer and the TEMP 120 USB port.
3. Apply 9.6 to 32 VDC external power using the green Power connector on the side of the
TEMP 120.
4. Select Connect Now
5. Select the communications port, it will be labelled similar to TEMP 120 (COM3).
6. Make selections for Speed or Noise Rejection and CAN enabled. See the SURVEYOR help
for more information on all settings.
7. Click Apply.
8. Select a Sample Rate. For this exercise, select 1/2 Hz.
. A video tutorial is available at
.
.
.
TEMP 120 2