Scope; Interferenceadvisor - Viavi InterferenceAdvisor Quick Manual

1. Scope

This document describes how to configure the InterferenceAdvisor and OneAdvisor 800 for interference
hunting.
The required products and parts to complete this procedure are as follows:
OneAdvisor 800 with the following functions:
- OneAdvisor 800 platform equipped with the following
modules and options:
o Any radio analysis module with optical hardware:
SPAMA-O: Optical HW
§
SPA06MA-O: Spectrum up to 6 GHz and
§
Optical HW
RA18MA-O: Spectrum up to 18 GHz and
§
Optical HW
RA32MA-O: Spectrum up to 32 GHz and
§
Optical HW
RA44MA-O: Spectrum up to 44 GHz and
§
Optical HW
ONA-SP-INTAN: Interference Analysis
§
ONA-SP-GNSS: GNSS function and antenna
§
o Optionally for TDD signals:
ONA-SP-TAGS: TDD Auto-Gated Spectrum
§
InterferenceAdvisor with the following functions:
- IA811: InterferenceAdvisor Accessories Kit
- IA811-001: InterferenceAdvisor EagleEye SW
- Optional functions:
o IA811-002: Spectrum Clearance for

InterferenceAdvisor

RF accessories
o G700050345: Omni-Directional Antenna
o G7000506xx: RF filters required for uplink analysis
2. InterferenceAdvisor
The InterferenceAdvisor is a fully automated, easy-to-use spectrum clearing and interference hunting
solution that allows users to validate spectrum clearness and quickly locate an interference source by
following guidance on a tablet-based map application.
The following procedure describes the steps to perform interference hunting with InterferenceAdvisor and
the OneAdvisor 800.
Description
Page 2 of 10
Diagram
OneAdvisor-800
InterferenceAdvisor
RF Filter
Omni-Directional
Antenna