Ricoh MP C6502SP Field Service Manual page 1372

5. Troubleshooting
Increase the width of the jogger fences when in standby mode from 7mm to 10mm.
See procedure below.
Procedure
Attach the modified docking bracket to make it possible to adjust side-to-side registration at joint
between mainframe and finisher in accordance with the procedure below.
1. Secure the docking bracket [A] in its default attachment position ( x 4).
Default attachment position (The screw head is centered)
2. Check the side-to-side registration by exiting to the proof tray.
1. Print out an A3 sheet to the proof tray.
2. Using the markings on the front-most exit roller (see photo below), check to see where the
paper edge is located when the paper is exited. For purposes of accuracy, print out about 5
sets.
1370