Ricoh MP C6502SP Field Service Manual page 1504

5. Troubleshooting
3. Confirm that pins [B] and [C] are passing through the two holes on the bracket shown.
• If the cover is not attached correctly, the pins may not pass through these holes. As a result,
the end fence will not move correctly, even if the spring is attached correctly.
Other 008: Skew in sub-scan direction
• The troubleshooting procedure described in this section is effective ONLY for skews smaller than
0.2mm on A3/DLT SEF or A4/LT LEF. Do not apply the procedures for skews greater than 0.2mm.
• The troubleshooting procedure will take approximately 3 to 4 hours.
• While skew in sub-scan direction can be caused by many factors, for example, paper in the tray is
set improperly, skewed OPC drum shaft, skewed ITB etc., the troubleshooting procedure described
in this section focuses on skews owing to an improperly set Laser Unit. If the skew is caused by other
factors, the skew will persist even after performing the troubleshooting procedure.
1502