8.9
Vehicle Transverse Inclination, "Zero
Position"
If the measured values are outside the allowed tolerances, the
cause may be an incorrect vehicle attitude.
Vehicles with automatic transmission can lean to one side slightly.
This is due to the installation position of the assemblies and the
corresponding weight transfer and is normal.
– It is absolutely necessary to measure dimension -a- on left and
right sides.
– Correct any differences if necessary.
It is possible to correct trim height imbalance for front axle by
adding weight to top of strut tower through the engine compart‐
ment.
To correct trim height imbalance for rear axle add weight to top
of strut tower through the trunk compartment.
For example, sand bags of approximately 10 kg (22 lb) are suit‐
able as weights.
8.10
Work Procedure Overview for Vehicle
Alignment
Observe the Following Work Sequence!
– Note the information in the alignment equipment.
Measuring Procedure
Start
Turn the steering wheel in‐
to the straight ahead posi‐
1)
tion and secure it
↓
Check camber at front axle
↓
←
↓
↓
←
↓
Check rear axle camber
Suspension, Wheels, Steering - Edition 08.2015
→
Perform wheel run-out com‐
pensation.
←
Measure vehicle height
→
Is actual value within toler‐
ance?
↓
←
Yes
←
←
→
Is actual value within toler‐
ance?
↓
Jetta 2011 ➤ , Jetta 2013 ➤
→
Bounce vehicle
↓
←
Install the Brake Pedal Actuator -
VAG1869/2- .
→
No
↓
Adjust. Refer to
⇒ "8.11 Front Axle Camber, Cor‐
recting", page 270
↓
←
←
→
No
↓
8. Wheel Alignment
.
269