Tie Rod End Allocation - Volkswagen Jetta 2011 Repair Manual

Perform the Following
– Check left tie rod for dimension "a" and adjust if necessary.
Dimension -a- = 376.6 ± 1 mm
Also check new tie rods for dimension "a" before installing and
adjust if necessary.
The total toe must be checked on the alignment rack and adjusted
if necessary. Refer to ⇒ "8 Wheel Alignment", page 256
Boot, Mounting
– Check the boot for wear (slits, cracks) and check the sealing
surfaces of the boot for dirt.
– Install the boot. Turn the tie rod so that the tie rod ball joint
shank is in the installation position.
– Tension the clamp using Hose Clip Pliers - VAG1275A- .
Only use original clamps.
Take care not to twist the boot when installing it.
8.7

Tie Rod End Allocation

I - Right Tie Rod End Is Identified with -A-
II - Left Tie Rod End Is Identified with -B-
Jetta 2011 ➤ , Jetta 2013 ➤
Suspension, Wheels, Steering - Edition 08.2015
8. Electromechanical Steering Gear, Servicing
343