Note
First tighten the bolt to the specification using the torque
♦
wrench.
Using a rigid wrench when tightening additionally.
♦
Caution
Never use an impact wrench when tightening the bolt -1- using
the Socket - XZN 18mm - T10162A- -2-.
– Install the new dust cap -1-.
Always Replace Dust Caps.
Damaged dust caps allow moisture to enter. Therefore, always
use the tool shown.
– Install the wheel and tighten. Refer to
⇒ "2 Wheel Installation Tightening Specifications",
page 237
.
Tightening Specifications
Component
Bolt for attaching the wheel bearing to the stub axle
♦ Use a new bolt
Jetta 2011 ➤ , Jetta 2013 ➤
Suspension, Wheels, Steering - Edition 08.2015
Tightening Specification
180 Nm + 180° turn
9. Wheel Bearing, Disc Brake (Torsion Beam)
181