Axle Beam Trailing Arm (Torsion Beam), Checking With Crankshaft Holding Fixture Vw801 - Volkswagen Jetta 2011 Repair Manual

8.5 Axle Beam Trailing Arm (Torsion
Beam), Checking with Crankshaft Hold‐
ing Fixture - VW801-
Caution
An inspection using the Crankshaft Holding Fixture - VW 801-
is only possible on axle beams without an axle beam plate. If
an axle beam plate is already installed, then the inspection
must be performed using the Measuring Square -
VAS241001-
⇒ "8.4 Axle Beam Trailing Arm (Torsion Beam), Checking with
Measuring Square VAS241001 ", page 260
Note
A traditional test of the rear axle as per the visual inspection/
♦
suspension measurement is not productive here. In order to
get a clear finding for the torsion beam trailing arm, the fol‐
lowing inspection instructions must be performed.
The test sequence is described for the left rear trailing arm.
♦
The test sequence for the right rear trailing arm is identical.
Special tools and workshop equipment required
♦ Crankshaft Holding Fixture - VW801-
♦ Gauge - Gap Adjustment - 3371-
♦ Measuring Square - VAS241001-
Test Sequence
– Loosen the wheel bolts.
– Raise the vehicle.
– Remove the left rear wheel.
Note
Do not use pointed or sharp tools to clean - there is a risk of cor‐
rosion.
– Thoroughly clean the contact surfaces -1- for the Crankshaft
Holding Fixture - VW801- on the trailing arm.
. Refer
.
Jetta 2011 ➤ , Jetta 2013 ➤
Suspension, Wheels, Steering - Edition 08.2015
to
263
8. Wheel Alignment