Volkswagen Jetta 2011 Repair Manual page 279

Note
Correct the camber according to Body Collision only. Camber
♦
corrections are not possible. Moving the subframe can also
adjust it.
Slide subframe only toward left or right, under no circumstan‐
♦
ces in or against direction of travel!
Perform the Following
– Remove the lower noise insulation. Refer to ⇒ Body Exterior;
Rep. Gr. 50 ; Noise Insulation .
– Loosen the subframe bolts -1 through 4- on the body.
– Loosen the subframe bolts -5 and 6- on the body.
Adjusting the camber is limited by the subframe hole tolerances.
If the specified value is not reached by moving the subframe, the
subframe and the assembly must be checked. Refer to
⇒ "1 Check List, Assessing the Suspension on Vehicles Involved
in a Collision", page 1 .
– By moving the subframe, only the specified value of the cam‐
ber can be adjusted.
– Bolt on subframe to body with additional torque angle using
new bolts.
– Remove the bolts -1- and remove the footwell trim panel -2-.
Jetta 2011 ➤ , Jetta 2013 ➤
Suspension, Wheels, Steering - Edition 08.2015
271
8. Wheel Alignment