Volkswagen Jetta 2011 Repair Manual page 184

Jetta 2011 ➤ , Jetta 2013 ➤
Suspension, Wheels, Steering - Edition 08.2015
– Press of dust cap.
1 - Puller - Grease Cap - VW637/2-
– Remove bolt -1- using Socket - XZN 18mm - T10162A- -2-.
Caution
Never use an impact wrench when removing the bolt -1- using
the Socket - XZN 18mm - T10162A- -2-.
– Remove the bolt -1-.
– Remove the wheel hub/wheel bearing unit from the stub axle.
Installing
Install in reverse order of removal. Note the following:
– Carefully install the wheel hub/wheel bearing unit -2- onto the
stub axle.
Caution
Make sure that the wheel hubs/wheel bearing unit does not tilt!
– Install the new bolt -1- and tighten it to the tightening specifi‐
cation.
176
Rep. Gr.42 - Rear Suspension