Crossbrace Bonded Rubber Bushing, Removing And Installing - Volkswagen Jetta 2011 Repair Manual

Perform the Following
Removing
– Raise the vehicle.
Secure Vehicle to Lifting Platform
1 - Tensioning Strap - T10038-
The Vehicle Could Fall Off the Hoist If It Is Not Secured.
– Remove the plug from the longitudinal member and install the
Tensioning Strap - T10038- .
– Remove the coil spring. Refer to
⇒ "6.2 Coil Spring, Removing and Installing", page 169
– Place the Engine and Gearbox Jack - VAS6931- under the
axle beam.
– Push the axle beam up until the crossbrace -2- is horizontal.
– Remove the threaded connection -1-.
– Remove the threaded connection -1- and the crossbrace -2-.
Installing
Install in reverse order of removal. Note the following:
– Install the coil spring. Refer to
⇒ "6.2 Coil Spring, Removing and Installing", page 169
Tightening Specifications
Component
Crossbrace to axle beam
♦ Always use new nuts and bolts.
Crossbrace to subframe
♦ Always use new nuts and bolts.
4.5 Crossbrace Bonded Rubber Bushing,
Removing and Installing
Special tools and workshop equipment required
♦ Press Piece - Front Control Arm - 2040-
Jetta 2011 ➤ , Jetta 2013 ➤
Suspension, Wheels, Steering - Edition 08.2015
.
.
Tightening Specification
70 Nm + 90° turn
70 Nm + 90° turn
4. Axle Beam, Subframe, Crossbrace (Torsion Beam)
159