Volkswagen Jetta 2011 Repair Manual page 357

Expansion Hose with Strap, Vehicles with 2.5L Engine
♦ The strap recess -1- on the expansion hose must be supported
by the steering gear -arrow-.
♦ The strap -2- on the return hose must be supported on the
expansion hose.
Expansion Hose without Strap, All Engines
♦ The expansion hose -1- must be supported by the steering
gear -arrow-.
♦ The strap -arrow- on the return hose -2- must be supported by
the expansion hose -1-.
– Install and tighten the noise insulation. Refer to ⇒ Body Ex‐
terior; Rep. Gr. 50 ; Noise Insulation for the tightening speci‐
fications.
– Install the front wheels and tighten. Refer to
⇒ "2 Wheel Installation Tightening Specifications", page 237
Tightening Specifications
Component
Steering gear to subframe
♦ Use new bolts.
Ball joint to control arm
♦ Use new nuts
♦ Tighten only in curb weight position. Refer to
⇒ "2 Rear Axle Curb Weight (Twist Beam Rear Sus‐
pension)", page 146
Subframe to body
♦ Use new bolts.
Stabilizer bar to coupling rod
♦ Use new nut
♦ Counterhold at joint pin inner multi-point fitting
Tie rod end to wheel bearing housing
♦ Use new nut
.
Jetta 2011 ➤ , Jetta 2013 ➤
Suspension, Wheels, Steering - Edition 08.2015
.
Tightening Specification
50 Nm + 90° turn
70 Nm + 180° turn
20 Nm + 90° turn
100 Nm
65 Nm
9. Hydraulic Power Steering
349