Setting Drive For Sliding/Tilting Sunroof To Zero Position; Performing Programming Run For Drive For Sliding/Tilting Sunroof - Volkswagen Jetta 2011 Workshop Manual

– Undo bolts -arrows- and pull off drive for sliding/tilting roof
-1-.
– Detach connector -2- from drive for sliding/tilting roof.
1.11.2 Installing
Carry out following work:
• Drive for sliding/tilting roof (zero position).
If this is not the case, set to "0" position
– Attach connector -2- to drive for sliding/tilting roof.
– Position drive for sliding/tilting roof -1- in mounting position and
screw in bolts -arrows-.
Specified torque for bolts -arrows-: 4 Nm.
– Install front interior light -W1- ⇒ Electrical system; Rep. gr.
96 ; Front interior light -W1- (with sliding roof) .
– Perform programming run for sliding/tilting roof
1.12 Setting drive for sliding/tilting sunroof to
zero position
Carry out following work:
– Electric motor removed; electrical connections connected.
– Use automatic preselector control function to select "Roof
closed".
– Electric motor runs into zero position and cuts out automati‐
cally.
– Install motor in this position with sliding roof closed.
1.13 Performing programming run for drive
for sliding/tilting sunroof
Note
Following removal and installation or renewal of the sliding/tilting
sunroof drive, the system needs to be conditioned to ensure that
the sliding/tilting sunroof works correctly.
– Switch on ignition and close doors; also close sliding roof if
open.
– Pull operating switch for sliding/tilting roof and hold in this po‐
sition for 10 seconds.
General body repairs, exterior - Edition 08.2012
⇒ page 163 .
⇒ page 163 .
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
1. Sunroof with glass panel
163