Replacing Parts - Angelo Po 190TP0 Use And Installation Manual

GREASING THE GAS TAP
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
panel (B).
4 - Undo the screws (D) and extract the cap (E).
5 - Pull off the cone (F).
6 - Clean the cone (F) and its seat.
7 - Coat the cone with grease (F), fit it in its seat
and turn it a few times.
8 - Pull off the cone (F) to remove the excess
grease.
9 - Replace the cone (F) and the cap (E).
10-Replace the control panel (B) and the knobs
(A) on completion of the operation.
Before carrying out any replacement proce-
dure, activate all the safety devices provided
and decide whether staff at work and those in the vi-
cinity should be informed. In particular, turn off the
gas supply tap and prevent access to all devices
which might cause unexpected health and safety
hazards if turned on. If work parts have to be re-
IT placed, use original spare parts only. The manufac-
GB
DE REPLACING THE PLATE BURNER NOZZLE
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
FR
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
ES
panel (B).
4 - Unscrew the nozzle (D) and replace it with the
one suitable for the type of gas in use (see table
at back of manual).
5 - Replace the control panel (B) and the knobs (A)
on completion of the operation.
English

REPLACING PARTS

RECOMMENDATIONS FOR REPLACING PARTS
C
A C B
turer declines all responsibly for injury or damage to
components due to the use of non original parts, or
extraordinary work on the appliance which may
modify the safety requirements without the manu-
facturer's authorisation. When ordering compo-
nents, follow the instructions provided in the parts
catalogue.
A
C
B
- 26 -
E F
D
IDM-39614602300.tif
C
D
IDM-39614801900.tif
8