Step Fill Table - Maretron MPOWER CLMD16 User Manual

CLMD16 User's Manual

Step Fill Table

In the Step Fill Table method, you start with an empty tank, and then fill the tank with fluid, stopping
at intermediate points to enter the amount of fluid put into the tank thus far, ending once the tank is
full. You may enter between two and sixteen calibration points. (see: Figure 25, Figure 26 & Figure
27),
Figure 25 - Current Loop Step Fill Calibration Tank, Initial Window Dialog Box
To use this method, use the following steps:
1) Enter the estimated total capacity of the tank into the "Total Capacity" text box.
2) Press the "Start Calibration" button. You will now see the Step Fill Calibration
window displayed, as shown below.
57
__