Connecting The Probe Cable To The Sera Tm; Connecting Transducers To The Preamplifier; Connecting The Electrode Cables To The Preamplifier - Interacoustics Sera Instructions For Use Manual

Connecting the probe cable to the Sera
The probe used with Sera
to the device:
1) Directly connected to the device (for OAE only)
2) Via the preamplifier cable (for OAE & Automated ABR)

Connecting transducers to the preamplifier

The preamplifier cable is required for Automated ABR testing and can also be used with all other modules.

Connecting the electrode cables to the preamplifier

D-0113323-F – 2020/11
Sera™ - Instructions for Use - US
is called the SnapPROBE
TM
Ensure that the Sera
probe or the preamplifier cable from the Sera
Align the raised dot on the probe plug/preamplifier cable plug with the one
on the front of the socket at the top of the Sera
it securely into place. The Sera
plug/preamplifier into the correct position.
Align the probe/insert phone/EarCup cable plug with the socket at the top
of the preamplifier cable marked with the graphic. Insert the plug and
push it securely into place. The Sera
plug/preamplifier into the correct position.
Connect the three electrode lead cables securely into the electrode jacks
on top of the preamplifier, matching the color of the cable with the jack.
Make sure they are fully inserted into the jack.
TM
. The SnapPROBE
TM
is switched off before attaching or detaching the
TM
is designed to guide the probe
TM
is designed to guide the probe
TM
can be connected in two ways
TM
.
TM
. Insert the plug and push
TM
Page 16