Battery Charging; Installing Label Paper In The Printer; Turning The Printer On And Off; Connecting The Wireless Printer To The Sera - Interacoustics Sera Instructions For Use Manual

3.4.1 Battery charging

3.4.2 Installing label paper in the printer

To insert a new label roll into the
label printer, open the printer by
sliding the button on the left side
of the printer downwards.
Optionally, thermal paper can be used with the HM-E200 thermal printer. Refer to the HM-E200 printer user
manual for setup instructions.

3.4.3 Turning the printer on and off

Push the POWER BUTTON for two seconds to power ON or OFF.
The Green Power Indicator is lit while the printer is on. Once the printer goes into standby, the green Power
Indicator will flash, while the display turns black. Push the power button shortly to get the printer out of
standby mode.

3.4.4 Connecting the wireless printer to the Sera

Pairing the printer to the Sera
Follow these instructions to pair the printer:
1. Turn the printer on by holding down the power button for 2 seconds
2. On the Sera
TM
3. Let the instrument search for wireless devices. This may take up to 1 minute
4. A device called HM-E200 should appear in the list of devices
5. Press Select to finish pairing
D-0113323-F – 2020/11
Sera™ - Instructions for Use - US
The printer is powered by a Lithium-ion battery.
In order to charge the battery, you must insert the plug of the charger
into the laterally placed socket and plug the power supply into a
power outlet or connect the printer to a PC. Alternatively, the printer
can be placed in its cradle while the cradle is connected to a power
outlet. The green light on the front side of the printer will flash to
indicate charging is occurring. Should the battery be fully charged,
the green light will be constant.
Insert the label roll into the printer
with the paper end placed facing
the printer display.
is necessary before wireless printing is possible.
TM
hand-held unit, go to Setup | Printer and press Search
Once the label roll is in place,
close the cover.
Turn the printer on and press
the feed button on the left side
so that the printer can properly
align the labels with the print
head.
TM
Page 13