Table of Contents
Advertisement
Installation Guide Linear Motors
Slider
12 mm
3.5 "Moving Slider" Installation
Slider back end
In a "moving slider" installation, the stator is fixed and the slider is the moving part.
The load, borne by a linear guide, is attached directly to the end of the slider. In order to compensate for
misalignment, spherical axial bearings consisting of spherical washers and conical seats (see the section
Slider mounting kits) are used to connect to the load. The mounting kit of slider and an oversized hole for the
screw make it possible to adjust a radial and angle offset.
If a mechanical end stop at the back end of the slider is required, make sure that the stator
cable is not kinked during operation.
Seite 10 / 30
Correct Mounting
Thread
Max. torque for screw (Stainless steel A4)
M5
Stator
Slider front end
Linear bearing
P01-23-HP-SSCP
Incorrect Mounting
Torsional stress on slider!
3.8 Nm
Spherical washer +
conical seat
ENG
Linear guide
NTI AG / LinMot
Advertisement
Table of Contents
