Table of Contents
Advertisement
Panel Mounting the MP6 Panels
If you do not want to use DIN-rail mounting, you can use panel (screw) mounting instead.
1. Remove and discard the MP6 mounting enclosures. This is done by removing two
screws on either end of each unit, then sliding out the printed circuit assembly
(PCA).
2. Use the four mounting holes provided on each MP6 panel to mount the PCA with
appropriate screws.
WARNING:
and comply with national and local electrical regulations
regarding spacing and insulation.
Plug-In Opto Modules on the MP6-M
The plug-in opto-isolator output modules are standard Opto-22 Generation-4 single-point
type, or equivalent. These modules have built-in indicator LEDs and are individually
fused. The mounting panels are supplied from Adept without I/O modules so you can
choose the type of modules (AC, DC, voltage range) which best suit your particular
application.
See
Section 2.10
for more detailed information on the opto modules.
Adept SmartMotion Installation Guide, Rev. B
Be sure to use suitable stand-offs or spacers
Installing MP6 Panels
27
- Quick Links:
- Product Description
Hide quick links:
Advertisement
Table of Contents
