System Safeguards; Safety Features On Front Panel; Computer Controlled Robots And Motion Devices; Manually Controlled Robots And Motion Devices - adept technology SmartMotion Installation Manual

There are several warnings in this manual that say only skilled or instructed persons
should attempt certain procedures. These are defined as:
• Skilled persons have technical knowledge or sufficient experience to enable them
to avoid the dangers which electricity may create (engineers and technicians).
• Instructed persons are adequately advised or supervised by skilled persons to
enable them to avoid the dangers which electricity may create (operating and
maintenance staff).

System Safeguards

Safeguards should be an integral part of robot or motion workcell design, installation,
operator training, and operating procedures.
Adept systems have various communication features to aid in constructing system
safeguards. These include the emergency stop circuitry and digital input and output lines.
Some of these features are described in the

Safety Features on Front Panel

The optional Front Panel has important safety features, including the
indicator, the
AUTO/MANUAL
choose not to use the Front Panel, you should provide similar safety features by using the
connectors on the SmartController. Refer to the
more information.
WARNING:
light is on can result in severe injury. This warning applies
to each of the next three sections.

Computer Controlled Robots and Motion Devices

Adept systems are computer controlled, and the program that is currently running the
robot or motion device may cause it to move at times or along paths you may not
anticipate. When the
the robot or motion device might move unexpectedly.

Manually Controlled Robots and Motion Devices

Adept robots and other motion devices can also be controlled manually when the
light on the Front Panel is illuminated. When this light is lit, motion can be
POWER
initiated from the system keyboard or from the optional Manual Control Pendant (MCP).
If you have to enter the workcell when this light is lit, press the
MCP. This will prevent anyone else from initiating unexpected motion from the system
keyboard.

Other Computer Controlled Devices

In addition, Adept systems can be programmed to control equipment or devices other
than the robot or main motion device. The program controlling these other devices may
cause them to operate unexpectedly. Make sure that safeguards are in place to prevent
personnel from entering the workcell when a program is running.
Adept SmartMotion Installation Guide, Rev. B
Adept SmartController User's
keyswitch, and the
Entering the workcell when the
light is illuminated, do not enter the workcell because
HIGH POWER
HIGH POWER
switch. If you
EMERGENCY STOP
Adept SmartController User's Guide
HIGH POWER
MAN/HALT
Safety
Guide.
for
HIGH
button on the
13