Installation Of Housing Components - Bosch FPA‑5000 System Information

Modular fire panel
2 Preparation
–
–
3 Installation of housing
Installation of wall mounting housing
Install:
–
–
–
–
–
–
–
Installation of frame installation housing
Install:
–
–
–
–
–
–
–
4 After installation
Store all documents.
4.3

Installation of Housing Components

Installation Instructions for Wall Mounting Housing and Mounting Frame
All listed mounting frames, wall mounting housings, and extension housings are supplied with
the following installation materials:
–
–
To install, proceed as follows:
1.
2.
3.
4.
5.
Installing Several Housings
It is possible to install several housings for frame mounting directly beneath each other by
connecting the frames to each other. The following instructions explain such an installation
using the example of the FBH 0000 A and FSH 0000 A mounting frames.
First, install the FBH 0000 A mounting frame as explained above (steps 1-5).
1.
Bosch Sicherheitssysteme GmbH
Lay the pre-cabling.
Optional: network cabling.
Housing
Optional: accessories for housing
Power supply bracket
Power supply unit and batteries
Panel rail
Panel controller
Functional modules
Mounting frames
Housing
Optional: accessories for housing
Power supply unit and batteries
Panel rail
Panel controller
Functional modules
3 6 x 50 mm screws
3 Ø 8 mm dowels
Mark the 3 required holes on the wall as shown in the installation drawing.
At the marked points, drill holes approx. 55 mm deep with an 8-mm drill. Insert a dowel
in each hole.
Screw the upper fixing screws to a distance of 5 mm from the wall and fit the housing or
mounting frame.
Now fit the third fixing screw. This 'safety' screw prevents the housing from being pushed
up and off the top screws.
Then check the installation position and securely tighten all screws.
Push the grooves of the FSH 0000 A Mounting Frame (2) onto the guide rails of the
FBH 0000 A Mounting Frame (1).
System Information
Installation | en 49
07.2020 | 12.0 | F.01U.028.089