1.0
Introduction
1.1
Before You Begin
Before installing the D1256 or D1257, you should be familiar with the Operation and Installation Guide and Program
Entry Guide for the control panel you are using. When using the D1256 or D1257 with the D9112B1 Control Panel, the
firmware must be Revision 2.1 or higher.
1.2
Type Styles Used Here
We use special type styles to help you identify the objects described in this guide.
Bold text usually indicates selections that you may use while programming your control panel. It can also indicate an
important fact to be noted.
Bold Italicized text represents a prompt when used in a description.
Italicized text references you to another section of the guide, or to a different guide. We also use Italicized text to
symbolize names for records that you will create.
Courier Text shows what may be printed on the Display or internal printer.
[CAPITALIZED TEXT] in brackets represents user input (keystrokes or buttons). Capitalization may also be used for
emphasis.
1.2.1
Tips, Notes, Cautions and Warnings
Throughout this document helpful tips and notes will be presented concerning the entire application and/or
programming the unit. They will be set off as follows:
Caution
These caution the operator that physical damage to the program and/or equipment may occur.
1.3
Organization and Layout
These installation instructions consist of three chapters and an appendix. Table 1 below provides a brief description of
each section.
Chapter 1
Chapter 2
Chapter 3
© 2004 Bosch Security Systems
Introduction
This is the chapter you are reading.
Overview
Description of the different parts of the D1256 & D1257.
Installation
Procedures on how to mount and wire the D1256 & D1257 plus procedures on programming
the control panel.
Table 1: D1256/D1257 Installation Instructions Organization
D1256/D1257 Installation Instructions
Page 5
D1256/D1257
Introduction
74-06925-000-H