Installation
10. Tighten the lock screws of the adjusting collar
using a torque wrench. Tightening torque: 3-5
Nm.
m
WARNING!
After finishing the adjustment, make sure the
distance between the adjusting collar and the
end of the thread is no more than 30 mm.
11. Fit the cylinder boots. Image 48.
30
Lift model
A
2500-130
142 ±5
2500-150
252 ±5
Max. 30 mm
Image 47. Adjusting the tilt angle
~ 10 mm
Image 48. Installing boots
ZHD 2500-130/150
A
www.zepro.com