Testing And Verification; Static Load Test - Zepro ZHD 2500-130 Installation Instructions Manual

Testing and verification
14

Testing and verification

Testing and verification of the tail lift takes place in accordance with the installation/delivery inspection. Verify
that the tail lift is suitable for the vehicle in question and for the intended use.
14.1

Static load test

14.1.1 Deformation
Position the tail lift half way up to the vehicle floor level and with the platform in the horizontal position. Meas-
ure dimensions A-B-C-D for comparison as illustrated.
Place a test load on the platform according to the table for the respective tail lift model and lifting capacity.
Remove the test load from the platform.
Repeat the measurement of A-B-C-D and verify that there has been no deformation of the lift or its fixing.
14.1.2 Drift
Place a test load on the platform according to the table. The tail lift must be at the same level and angle as
the vehicle floor. Leave the test load for 15 minutes.
Verify that the platform drift is no more than 15 mm on the vertical (points A and D) and 2º in terms of the
angle.
14.1.3 Static load (Test load 1.25 x tail lift loading capacity). For tail lifts with load
centre of 1000 mm
Capacity Load 1500 kg
Distance out in platform (L)
2500 kg 2120 mm
C
60
Load 2000 kg
1560 mm
D
B
Deformation
Max 2º
Image 69. Testing and verification
A
D
C
B
Drift
ZHD 2500-130/150
A
Max. 15 mm
www.zepro.com