Installation
6.12.2
Adjusting the downward
tilt angle
NOTE.
The tilt angle must be set at 90° to the vehicle body
before the downward tilt angle is adjusted (see
previous page).
m
WARNING!
To ensure that the lift is safe and CE compliant, the
downward tilt angle must be adjusted to max. 10° if
there are going to be people on the platform.
1. Raise the lift to the vehicle floor. Image 49.
2. Loosen the lock screw of the end stop (2). Screw
the end stop all the way back towards the platform
(3). Image 50.
3. Tilt the platform down to max. 10 degrees below
the horizontal. Image 49.
4. Adjust the end stop all the way to the top of the
cylinder (4). Image 50.
5. Tighten the lock screw in the end stop (5). Image
50.
The tightening torque for lock screws
is 3-5 Nm
Test all functions.
www.zepro.com
Adjusting collar
Lock screw
Bolt
Washer
Image 51. Tilt cylinder
Image 49. The tilt angle must be ad-
justed to max.10° down
2
5
3
4
Image 50. End stop with lock screw
End stop
ZHD 2500-130/150
31