Zepro ZHD 2500-130 Installation Instructions Manual page 29

Installation
4. Turn the adjusting collar so that the platform just
meets the seal on the vehicle body. Image 44.
5. Loosen the three lock screws on the other tilt
cylinder. Image 45.
6. Turn the adjusting collar so that the tilt cylinder
aligns with the attachment on the platform. See
Image 45.
m
WARNING!
The max. length of both cylinders must be
adjusted equally to avoid unwanted breakout
forces.
7. Fit the other tilting cylinder to the platform
mounting. Use the supplied shaft and support
wheel.
NOTE.
Make sure the cylinder is installed with the
grease nipple facing up.
8. Tighten the bolts using a torque wrench.
Tightening torque: 80 Nm.
9. Adjust the two cylinders alternately so that the
platform meets the vehicle body. See Image 44 (B).
www.zepro.com
Image 44. Adjusting the fit with the vehicle body
Out
In
Image 45. Adjusting the tilt angle
Image 46. Fitting the tilt cylinder to the platform
ZHD 2500-130/150
Lock screws, 3 pcs.
29