Rear Pto Shaft - Warning; Setting Of The Display Of The Rear Pto Shaft Speed - Zetor Proxima CL 80 Operator's Manual

Rear PTO shaft - warning

In connection with the operation of the rear PTO shaft, the following warnings are shown on the display of
the instrument panel:
A - warning - when the rear PTO shaft is activated by the button and the gear shift lever of dependent and
independent revolutions is in the neutral position, use the lever to shift independent revolutions of the rear
PTO shaft and use the button to restart the rear PTO shaft
B - warning - when the rear PTO shaft is deactivated by the button, the gear shift lever of dependent and
independent revolutions remained in the position of independent revolutions of the rear PTO shaft longer
than 5 minutes, move the lever to the neutral position
C - defect indication - when the rear PTO shaft is deactivated by the button and the gear shift lever of
dependent and independent revolutions remained in the position of independent revolutions of the rear PTO
shaft longer than 15 minutes, this state will be recorded in the listing of defects.

Setting of the display of the rear PTO shaft speed

By pressing the button (B) enter the service menu
1 - Use the buttons (C) and (D) to select the item CALIBRATION indicated with the arrow (1) and by pressing
the button (B) (ENTER) you enter the CALIBRATION menu.
2 - Use the buttons (B) and (C) to select the item SETTING OF PTO REVOLUTIONS indicated with the
arrow (2) and by pressing the button (B) (ENTER) you enter the next screen.
3 - Screen for setting the rear PTO shaft revolutions. Use the buttons (C) and (D) to select the corresponding
revolutions of the rear PTO shaft which will be used. Confirm the setting with the button (B) (ENTER). The
selected revolutions are indicated by the symbol see arrow (3). By pressing the button (A) repeatedly you
exit the menu to the main screen.
4 - The selected revolutions of the rear PTO shaft are shown on the display of the instrument panel - see
arrow (4).
The correct shift PTO speed must be chosen for proper display of the PTO speed!
The setting is only used for display of data, shifting of the corresponding gear must be
performed with the lever depending on the combination of revolutions of the PTO shaft the tractor is
equipped with.
98
PTO DRIVE OF AGRICULTURAL MACHINES
P18N080
P18N014